Variable Speed, Inline Circulation Pump, 63 lpm

Product Information

DAB VA55/130 Inline Circulation Pump

A general purpose, variable speed circulation pump, designed for heating systems, but suitable for use with other fluids that are not chemically agressive to its component materials. These pumps are widely used on biodiesel reactors or as a low cost, inline dispensing pump for thin viscosity fuels.

Optional Fitting Kit brings 1.5" BSP Male cast threads down to 1" BSP Female. Fitting Kits are available in brass only

Wetted Components
Pump Body	Cast Iron (Painted)
Impellor Case	Cast Iron (Painted)
Impellor Case Seal	NBR
Motor Shaft Seal	NBR
Thrust Washer	Ceramic
Rotor Protection Jacket	Stainless Steel
Rotor / Gear / Impellor	Technopolymer
Shaft Key / Nut	Stainless Steel
Motor Shaft	Stainless Steel
Bypass Valve Piston	Not Present
Bypass Valve Seal	Not Present
Bypass Valve Spring	Not Present

Performance
Voltage / Frequency	230v / 50Hz
kW	0.045 to 0.082
Amps	0.24 to 0.36
RPM	1330, 1815, or 2330
Duty Cycle	Continuous
Cable Length	Not Present
Bypass Valve Y/N	N
Max Flow	63 lpm @ 0 m head (2330 RPM)
Discharge Pressure	0.5 Bar / 7.25 PSI
Max Suction Lift (Dry)	None
Max Suction Lift (Wet)
Inlet Fitting	1.5" BSP Male
Outlet Fitting	1.5" BSP Male
Max Particle Tolerance	100 Micron
Max Liquid Temp	90 Celcius
Min Liquid Temp
Max Room Temp	40 Celcius
Min Room Temp
Thermal Protection Y/N	N
Max Liquid Viscosity	Water
Ingress Protection	None